[. . . ] Insert the release pin into the hole in the bottom of the frame and pull out to remove the frame. If you do not operate the removing and attaching the front panel function, use the supplied fixing screws to fix the front panel to this unit. Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. Select a position where the screw holes of the bracket and the screw holes of the head unit become aligned (are fitted), and tighten the screws at 2 places on each side. [. . . ] Insert the release pin into the hole in the bottom of the frame and pull out to remove the frame. Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out. This product features two operation modes: the 3-way network mode (NW) and the standard mode (STD). Use a thin standard tip screwdriver to switch the DSP switch on the bottom of this product. Support Après avoir introduit le support dans le tableau de bord, sélectíonnez les languettes appropriées en fonction de l'épaisseur du matériau du tableau de bord et courbez-les. Yellow (2*) To terminal always supplied with power regardless of ignition switch position. Yellow (2*) To terminal always supplied with power regardless of ignition switch position. ISO connector Note: In some vehicles, the ISO connector may be divided into two. Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. If the RCA pin jack on the unit will not be used, do not remove the caps attached to the end of the connector. Speakers connected to this unit must be highpower types with minimum rating of 50 W and impedance of 4 to 8 ohms. Connecting speakers with output and/or impedance values other than those noted here may result in the speakers catching fire, emitting smoke or becoming damaged. When this product's source is switched ON, a control signal is output through the blue/white lead. When an external power amp is being used with this system, be sure not to connect the blue/white lead to the amp's power terminal. Likewise, do not connect the blue/white lead to the power terminal of the auto-antenna. To avoid short-circuiting, cover the disconnected lead with insulating tape. There is a possibility of short-circuiting if the leads are not insulated. If this unit is installed in a vehicle that does not have an ACC (accessory) position on the ignition switch, the red lead of the unit should be connected to a terminal coupled with ignition switch ON/OFF operations. If this is not done, the vehicle battery may be drained when you are away from the vehicle for several hours. [. . . ] If this is not done, the vehicle battery may be drained when you are away from the vehicle for several hours. Yellow (2*) To terminal always supplied with power regardless of ignition switch position. ISO connector Note: In some vehicles, the ISO connector may be divided into two. Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. [. . . ]